Metallurgical Abstracts on Light Metals and Alloys vol.54
Dissimilar Laser Brazing of Aluminum alloy and Galvannealed Steel and Defect Control Using Interlayer
Tomo Ogura*, Reiko Wakazono*, Shotaro Yamashita* and Kazuyoshi Saida*
*Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University
[Published in Welding in the World, Vol. 64 (2020), pp. 697–706]
https://link.springer.com/article/10.1007/s40194-020-00858-7
E-mail: tomo.ogura[at]mapse.eng.osaka-u.ac.jp
Key Words：Laser brazing, Aluminum alloys, galvannealed steel, Dissimilar materials, interlayer
The microstructure and tensile shear strength of the joint by laser brazing between dissimilar metals of aluminum alloy and galvannealed (GA) steel were investigated. A blowhole was formed by zinc vaporization during laser brazing; the tensile shear strength was significantly affected not by intermetallic compounds (IMCs) at the filler metal/GA steel interface but by the blowhole. The vaporization of zinc was suppressed, and the blowhole was controlled by inserting a Ti interlayer. The joint strength was improved through the suppression of blowhole, the thermal deformation of the Ti interlayer, and the increase in brazed filler metal thickness by optimizing the brazing parameter. The hardness test revealed that fracture occurs preferentially in the brazed filler metal; however, as the brazed filler thickness increases, fracture begins to occur near the heat-affected zone of A5052 because the volume of filler metal increases. The maximum strength of the joint was 185 N/mm, which is about 73% of the joint efficiency to 254 N/mm of the A5052 base material, and the base material partly fractured.